User's Manual
Table Of Contents
- Notice
- OLE_LINK1
- OLE_LINK2
- Environmental_Protection
- Symbols
- Safety_and_Compliance_Information
- Safety_Information
- Regulatory_Compliance
- FCC_Part_15
- This_device_may_not_cause_harmful_interf
- This_device_must_accept_any_interference
- LVD/EMC_Directive
- WEEE_Directive–2002/96/EC
- _GoBack
- Adjusting_and_Setting_with_Menus
- _bookmark9
- PICTURE_Menu
- _bookmark17
- Adjusting_the_Camera
- _bookmark26
- Appendix
- Troubleshooting
- Menu_Configuration
- License
VS-PTC-IP Manual
www.marshall-usa.com 20
• If setting the IP address to DHCP, move the cursor to the Type field, and rotate the Zoom Speed dial to change
the value to DHCP. Click the Zoom Speed dial to save
• If setting the IP address to a STATIC address, ensure that the Type field shows STATIC, and then rotate the
P/T Speed dial to move the cursor between the IP address octets. Move the cursor to each octet and use the
alphanumeric keypad to enter its value. Rotate the P/T Speed dial to move to the next octet and repeat until all IP
address octets are set to the desired values.
• Click the Zoom Speed dial to save
• Edit the Subnet Mask and Gateway as necessary to communicate on your network
• Click the Zoom Speed dial to save
• Exit this menu
Button Light
The Button Light value affects the brightness of the button backlight
• Rotate the Zoom Speed dial to adjust the value
• Click the Zoom Speed Dial to save
• Exit this menu