User's Manual
Table Of Contents
- Notice
- OLE_LINK1
- OLE_LINK2
- Environmental_Protection
- Symbols
- Safety_and_Compliance_Information
- Safety_Information
- Regulatory_Compliance
- FCC_Part_15
- This_device_may_not_cause_harmful_interf
- This_device_must_accept_any_interference
- LVD/EMC_Directive
- WEEE_Directive–2002/96/EC
- _GoBack
- Adjusting_and_Setting_with_Menus
- _bookmark9
- PICTURE_Menu
- _bookmark17
- Adjusting_the_Camera
- _bookmark26
- Appendix
- Troubleshooting
- Menu_Configuration
- License
13
RS232 connection
1. Follow the diagram below for the following options:
• 1 to 1 connection, Marshall camera ONLY - Use the included (premade) Ethernet cable direct connect or standard
Ethernet cable.
• 1 to 1 connection, Non-Marshall camera – Follow the pinout for the RS232 port on the keyboard to make a cable
suitable for controlling your camera
VS-PTC-IP
Cat5 Ethernet (RJ45) Cable
RS232 up to 100m
CV620-CABLE-07
Cat (RJ45) to
RS232 8-pin
on each camera
CV612/CV620/CV630
Marshall CV620-Cable-07
Ethernet to 8-pin (RS232)
*sold separately