User's Manual
Table Of Contents
- Notice
- OLE_LINK1
- OLE_LINK2
- Environmental_Protection
- Symbols
- Safety_and_Compliance_Information
- Safety_Information
- Regulatory_Compliance
- FCC_Part_15
- This_device_may_not_cause_harmful_interf
- This_device_must_accept_any_interference
- LVD/EMC_Directive
- WEEE_Directive–2002/96/EC
- _GoBack
- Adjusting_and_Setting_with_Menus
- _bookmark9
- PICTURE_Menu
- _bookmark17
- Adjusting_the_Camera
- _bookmark26
- Appendix
- Troubleshooting
- Menu_Configuration
- License
11
Initial Setup
Power
Power up the controller using one of the following options:
1. Power supply (included)
• Power Voltage Tolerance 9V – 12V
2. Use POE (connect Ethernet IP port to POE switch)
• Maximum distance 80M using CAT6 Plus cable
3. Use included junction box
• Connect junction box to power supply
• Connect Ethernet cable from “Controller” port on the junction box to the RS422 or RS232 port on the VS-
PTC-IP
• When using Junction Box to provide power to the keyboard via RS422 or RS232 port on the keyboard. Does
not need extra power supply for keyboard.
Figure 3 - Power supply is required at EITHER the keyboard OR the Junction Box. If the junction box is powered, no additional
power supply is needed for the keyboard, as the junction box will provide power to the keyboard via the control port