User's Manual
Table Of Contents
- Notice
- OLE_LINK1
- OLE_LINK2
- Environmental_Protection
- Symbols
- Safety_and_Compliance_Information
- Safety_Information
- Regulatory_Compliance
- FCC_Part_15
- This_device_may_not_cause_harmful_interf
- This_device_must_accept_any_interference
- LVD/EMC_Directive
- WEEE_Directive–2002/96/EC
- _GoBack
- Adjusting_and_Setting_with_Menus
- _bookmark9
- PICTURE_Menu
- _bookmark17
- Adjusting_the_Camera
- _bookmark26
- Appendix
- Troubleshooting
- Menu_Configuration
- License
VS-PTC-IP Manual
www.marshall-usa.com 10
System Overview
Connection
The controller supports serial RS232/RS422 and IP Cross protocol mix-control. It allows you to use RS232/RS422/
IP control on one controller to control cameras (Protocol support: VISCA, PELCO D/P, ONVIF, VISCA over IP, CGI*) in
a single system.
Depending on the protocol being used to control the cameras, you may need to connect one or more of the following:
IP port to network switch
• Used for logging in to web interface of VS-PTC-IP
• Used to control the following PTZ protocols:
• VISCA over IP
• ONVIF
• RS232 Connection1 to 1 connection with keyboard and camera
• Keyboard connection to RS232 daisy chain
RS422 Connection
• Keyboard RS422 (A or B) RJ-45 port to RS422 adapter to RS422 cameras (daisy chain)
• Keyboard RS422 (A or B) RJ-45 port to RS422 adapter to RS485 cameras.
7 Cameras
via RS232
Up to 100 Cameras
& 16 additional
Controllers
on single IP Network
7 Cameras
RS422 (Visca)
on Channel A
7 Cameras
RS422 (Visca)
on Channel B
Simultaneous setup & control of
7 (RS232), 14 (RS422) & 100 (IP)
cameras of different makes & models
on a single VS-PTC-IP system
IP, ONVIF
Visca over IP
255 Cameras
RS485 (Pelco)