User Manual

4- Remote Configuration
___________________________________________________________________________
User Manual VS-102 HDSD/HDI - V2.3 Page 40 of 64 5/7/12
This server has Two Sensor Ports and Two Alarm Ports. When a decoder is
connected to the server, instead of a PC client, one system becomes a Local System
and the other becomes a Remote System. Actions can be configured for events from
the Remote System as well as for the Local System. For Example: It is possible to turn
on an alarm device such as a Local (Center) Decoder System when a Sensor Device
in Remote (Site) IP Camera is triggered. Local Section configures the actions for
events from Local (Self) System and activates Local Devices, while the Remote
Section is used to configure the actions for events from Remote (Peer) System.
The following table shows possible event actions:
Action Description
Beep Triggers Beep Port.
Alarm Out Triggers Alarm (Relay) Port.
Email
Sends Email to the specified address.
AVI file can be attached
FTP Upload AVI File to a specified FTP Server
Preset Move to the Preset Position
Local & Remote Event Configuration
 Sensor1 / Sensor2
Configure the actions when the sensor is activated. Multiple actions can be set for a
single event.
 On Video Loss
Configure the actions when video input signal is lost. Multiple actions can be set for a
single event.
 On Motion
Configure the actions when motion is detected. Multiple actions can be set for a single
event.
 On Disconnect
Configure the actions when the link (connection) to peer system is disconnected.
Multiple actions can be set for a single event. This event happens when the last client
which has been receiving video from the camera, loses the connection.
Alarm Duration and Beep Activation
 Set the duration of alarm or beep activation for each event. If it is set to continuous,
it will be active until it is manually reset.