User Manual

4- Remote Configuration
___________________________________________________________________________
User Manual VS-102 HDSD/HDI - V2.3 Page 37 of 64 5/7/12
Serial Port Configuration
 Serial Protocol: Two Serial Ports are on the Video Server: RS-232 & RS-422/485.
(For the RS-422/485 Port, select RS-422 or RS-485).
 Serial Port Configuration: The Serial Ports can be configured with the following
options:
NOTE: Each Serial Port Configuration must be the same as the Connecting Device.
PTZ
 PTZ Type: Select the PTZ Type: Camera or Receiver.
 PTZ ID: Each Camera or Receiver is assigned a Unique ID since it is possible to
control multiple PTZ cameras and receivers over single control line. Enter the PTZ ID
for each camera or receiver for control. The ID value ranges between 0 and 255.
 PTZ Port: Select the Serial Port used for PTZ Camera Control.
Sensor Type
There are Two Sensor Input Ports on the Video Server. Each Sensor Port can be
configured with the following options:
The function of the sensor port is set based on the type of the sensor connected.
Mode Selection
Bit Rate
2400, 4800, 9600, 19200,
38400, 57600, 115200 bps
Data Bits 5, 6, 7, 8 bits
Parity NONE, EVEN, ODD bit
Stop Bit 1, 2 bit
Function Operation
OFF
Not used.
NO (Normally Open)
The port is normally open and activated
when closed.
NC (Normally Closed)
The port is normally closed and
activated when opened.