User Manual

2- Installation
___________________________________________________________________________
User Manual VS-102 HDSD/HDI - V2.3 Page 11 of 64 5/7/12
2.1 Connecting Video
 Encoder System
Connect camera video output line to the encoder (video server) video input port.
 Connecting with Megapixel Camera
Connect a camera which supports HDMI or HD-SDI output to the HDMI or HD-SDI
Input port of video server accordingly.
 Connecting with D1 Resolution Camera
Connect a camera to the Video Input port of video server accordingly.
 Decoder System
Connect a monitor to HDMI or COMPOSITE (HD-SDI) Output port of video server
accordingly.
2.2 Connecting Audio
Audio is Full-Duplex. It is possible to set the mode as Tx-only, Rx-only or Tx-Rx.
 Connect audio input and output ports to audio devices accordingly.
 The Audio signal required is line level, so audio equipment with an amp, mixer or
other amplifier should be used.
2.3 Connecting Serial Ports
For camera control, PTZ Controller (keyboard) and Receiver can be connected to Serial
Ports. Two corresponding Serial Ports in the Encoder and Decoder which are
connected 1-to-1, works in Pass-Through Mode. This means that commands at a local
system’s COM1 Port will be transparently passed to the remote system’s COM1 Port.
Commands at a local system COM2 Port will pass to the remote system’s COM2 Port.
2.4 Connecting Sensor and Alarm
Connect Sensor and Alarm Devices to corresponding terminals accordingly.
2.5 Connecting Power
After confirming the Power Source, connect Power Adaptor and connect the 12VDC
Connector to the System.