Manual

Page 10 of 36
Front Panel Features
Power Button with Indicator
Press power switch to turn on the Unit. The indicator LED will turn Green. Press again turn Off.
Tri-Color Tally Ligh t
30mm Tri-Color tally lamp controlled via the Remote connector on the rear of the unit.
User-Assignable Function Keys
Nine user-assignable function buttons can be used for direct access to various settings. Functions
are assigned using the on-screen menu.
Rotary Encoder
The Rotary Encoder may is used for the following five functions.
 Volume
 Peaking
 Brightness
 Contrast
 Chroma
ROTOMENU Control
Press and hold the ROTOMENU Encoder to access the on-screen Menu. Turn the encoder to the
Left or Right to navigate Up and Down on the on-screen menu. Press the encoder to select the
sub-menu. When you arrive at the sub-menu or value you wish to modify, turn the encoder to select
the new value and then press the Encoder to save the change. If you exit the data entry submenu
before pressing the Encoder, the changes will not be saved. You may exit sub-menus by turning
the Encoder to the Return heading and pressing the Encoder to select, or simply by pressing the F9
key.
Headphone Jack
3.5mm stereo headphone jack. Left and Right source are selected from the on-screen menu.





Page 27 of 36
WAVEFORM SUBMENU
■ Layout:
Use this menu to choose from several available
preset screen layouts. Choosing any of the available
preset layouts will override the settings in the
Waveform, Size and Position menus.
■ Waveform:
Use this menu to turn the Waveform display On or Off
when in the Normal mode.
■ Size:
Use this menu to choose the size of the Waveform
display in Normal mode. Choices are Small, Medium,
and Large.
■ Position:
Use this menu to select the position you want the Waveform display to occupy on the screen when in
the Normal mode. Choices are Left Top, Left Bottom, Right Top, and Right Bottom.
■ Display Type:
Use this menu to choose how to display the waveform. The choices are Overlay or Overlap. In the
Overlay mode, the waveform will be semi-transparent and the user will be able to see the source video
through the waveform. In the Overlap mode, the waveform will be Opaque and will block the source
video.
■ Y Over Limit:
Use this menu to set where you want the waveform to display Red when the video source exceeds the
limit set. This value is adjustable from -7.3% to 109.1% IRE. This setting is shared with the ClipGuide
Menu.
■ Y Under Limit:
Use this menu to set where you want the waveform to display Red when the video source below the
limit set. This value is adjustable from -7.3% to 109.1% IRE. This setting is shared with the ClipGuide
Menu.
 Limits
o Internally, Y values ranges from 0 to 255.
o -7.3 IRE is equal to 0 in digital.
o 0 IRE is equal to 16 in digital.
o 100 IRE is equal to 235 in digital.
o 109.1 IRE is equal to 255 in digital
■ HISTOGRAM:
Use this menu to turn the Histogram function ON or OFF as well as set the Histogram display postion.