User Manual

SCREEN SUBMENU
■ Scan
Normal (Zero Scan)
• Whole picture should be visible without any cropping.
• When in normal mode, it should not see non-active
areas such as SAV, EAV.
Over (End-User TV Production Scan)
• 5% of the picture is cropped and zoomed to ll the screen.
• After cropping, it will maintain correct aspect ratio and
center.
Zoom
• When in zoom mode, the center portion of the picture is
magnied to ll the screen by approximately 4x.
■ Aspect Ratio Settings
Use to switch between Full Screen, 4:3 and 16:9 aspect ratios.
As the OR-701A monitor has a native resolution of 800 x 480 RGB pixels, incoming images are automatically
scaled to t the screen:
• In Auto mode, images are displayed in their native Aspect Ratio. SD is normally 4:3 / HD normally 16:9.
• In 4:3 mode, images are scaled to ll the maximum 4:3 portion of the screen (640 x 480), with black
bars lling the remainder of the screen, regardless of its original format.
• In 16:9 mode, images are scaled to ll the maximum 16:9 portion of the screen (800 x 480) regardless of
its original format.
■ Mono / Color
Use the Mono / Color modes for monitor calibration or to analyze individual color components of an image.
• RGB = displays all three colors (Normal display)
• Mono = displays as monochrome.
• Red Channel = displays red channel only.
• Green Channel = displays green channel only
• Blue Channel = displays blue channel only
• R+G = Red + Green
• R+B = Red + Blue
• G+B = Green + Blue
AUTO with 16:9 source 16:9 with 4:3 source 4:3 Mode with 16:9 source or
native 4:3 in AUTO mode.
■ H/V Delay
Use this setting to enable H & V Delay
• In H & V Delay mode, both horizontal sync and vertical sync are delayed, resulting in both horizontal
and vertical blanking periods being shown at the center of the screen.
■ Shift H
Use the Up-éand Down-ê menu buttons to change the value of this setting will shift the picture Horizontally.
Negative values will move the picture Right, while Positive values will move the picture Left. [0] is center
value.
14
■ Shift V
Use the Up-éand Down-ê menu buttons to change the value of this setting, which will shift the picture
Vertically. Negative values will move the picture DOWN, while Positive values will move the picture UP.
MARKER CONFIGURATION SUBMENU
■ Marker
Use this setting to enable or disable all on-screen markers.
This setting affects the Center marker, Aspect markers, and
Safety marker.
■ Center Marker
Use this setting to display a center marker on the screen.
■ Aspect Markers
Use these settings to superimpose one of 6 markers on the
screen when in 16:9 mode.
• 4:3
• 16:9
• 1.85:1
• 2.35:1
• 4:3 and 1.85:1
• 4:3 and 2.35:1
■ Safety Marker
Use this setting to adjust the safety marker from 80% to 100% (Off) in 1% steps.
OFF (No Marker) 2.35:1 Aspect Ratio 4:3 Aspect Ratio Marker 90% Safe Area
■ Marker Mat
Use this setting to change the format of the marker curtains between Clear, Halftone, or Black.
■ Line Thickness
Use this setting to choose the line thickness of the markers from 1, 2, or 3 pixels thick.
■ Line Type
Use this setting to select the style of line used for markers between White, Halftone, and Invert.
Example (80% Marker in 4:3 Mode):
Normal Background Black Background
15