Manual

Page 24 of 39
SCREEN SUBMENU
■ Scan
 Normal (Zero Scan)
The whole picture should be visible
without any cropping. When in normal mode
you should not see non-active areas such as
SAV, EAV.
 Over (End-User TV Production Scan)
5% of the picture is cropped and zoomed
to fill the screen. After cropping, it will
maintain correct aspect ratio and center.
 Zoom
When in zoom mode, the center portion
of the picture is magnified to fill the screen by
approximately 4x.
■ Aspect Ratio Settings
Use to switch between Full Screen, 4:3 and 16:9 aspect ratios.
The 960 x 540 resolution panel was chosen to allow monitoring of HD 1920 x 1080 video
formats without scaling artifacts.
■ Mono / Color
Use the Mono / Color modes for monitor calibration or to analyze individual color
components of an image.
 RGB = displays all three colors (Normal display)
 Mono = displays as monochrome
 Red Channel = displays red channel only
 Green Channel = displays green channel only
 Blue Channel = displays blue channel only
■ H/V Delay
Use this setting to enable H & V Delay.
In H & V Delay mode, both horizontal sync and vertical sync are delayed, resulting in
both horizontal and vertical blanking periods being shown at the center of the screen.
■ Shift H
Use the RotoMenu control to change the value of this setting which will shift the picture
horizontally. Negative values will move the picture RIGHT, while Positive values will
move the picture LEFT. [0] is center value.
■ Shift V
Use the RotoMenu control to change the value of this setting, which will shift the picture
Vertically. Negative values will move the picture DOWN, while Positive values will move
the picture UP.
■ 3D Review
Use this to control the 3D monitoring modes.
 OFF
 LEFT EYE
 RIGHT EYE
 BLENDING
 LUMINANCE DIFF
 CHROMA DIFF
■ Anaglyph
Use this for monitoring the 3D image using Anaglyph Glasses.
 OFF
 COLOR
 HALF COLOR
 OPTIMIZED
 GRAY