User Manual
ITEMS OPTIONS
Language English / Español
LOGO ON / OFF
Color Bar ON / OFF
Backlight 0 – 100
Reset ON / OFF
OSD OSD Horizontal position 0 – 100
OSD Vertical position 0 – 100
OSD Timeout 5s, 10s, 15s
IP Config DHCP
ON: Obtain an IP address automatically.
OFF: Obtain an IP address manually.
System Displays current status and firmware level
ISP Initiate firmware update.
Exit
YCbCr – a graphic representation of the Luminance plus the color components in the video signal. Useful
for equipment adjustment and conrming proper operation.
RGB – a graphic representation of the three primary color components of video picture. Useful for making
equipment adjustments.
Vector – a graphic representation of the colors in a picture. Brightness levels are not shown. The vector
display is used with color charts or test signals. It is of little value during a video production.
Default – creates reduced size representations of each waveform listed above. In this mode, the video
picture is visible at the same time as the waveforms.
Colorize Waveform - When ON, the waveforms will have unique colors to make it easy to identify what is
being graphed. When OFF, all waveforms will be white on black.
Limits – when ON, will “cut” the top and bottom of the waveform at the Level Maximum and Minimum (8-
bit digital values). This is primarily a troubleshooting tool for digital systems and not typically used during
video production.
Vectorscope Targets - Vectorscope targets are small boxes that show where test signal color bars are
supposed to be. They are meaningful only when they are set to match the source being measured:
• 75% for typical split eld color bars (most common)
• 100% for chroma-boosted “100%” color bars
Language – sets on-screen messages to either English or Spanish
LOGO – selects whether the Marshall Electronics logo appears at power up
Color Bar – places color bars on screen to check the monitor operation
6. SETTING
The Setting page provides a collection of system-level
functions including On Screen Display (OSD), Ethernet
port settings (IP Cong), reset unit to Factory settings
(Reset) and rmware update (ISP).
9
M-LYNX-702W / Menu Settings