User Manual

10
Marshall Electronics
Backlight – adjusts the brightness of the LCD backlight. This is different from the “Brightness” control.
Backlight is adjusted to compensate for room lighting without upsetting Contrast and Brightness
adjustments.
Reset – sets all menu items back to the way the unit ships from the factory.
OSD – adjusts the position of the on-screen display messages and menus. The amount of time menus
remain on screen can also be adjusted.
IP Config – opens a sub-menu where the monitor’s IP address can be set.
System – displays status messages only. There are no adjustments
ISP – works with the application on the enclosed CD to allow rmware updates
USER FUNCTION SHORT CUT (F1 – F4) MENU
USER FUNCTION SHORT CUT (F1 – F4) MENU
The monitor front panel has four special function keys marked F1 through F4.
These are pre-programmed as short cuts keys per this table:
FUNCTION KEY STANDARD SHORT CUTS
F1 Peaking
F2 Waveform / Vector
F3 Audio Bars & Phase Scope
F4 Histogram
These function keys may be re-programmed at any time by first pressing the
function key for about three seconds. The function key menu will appear at the
right side of the screen. Simply rotate the Menu knob to the desired function
short cut and press the Menu knob to make the selection.
One of the following shortcuts may be programmed to each function key:
OPTIONAL SHORT CUTS
Screen Marker Image Flip Peaking
Aspect Marker Zoom False Color
Check Field Pixel-to-Pixel Exposure
Color Bars Image Freeze Histogram
Aspect Ratio Underscan Audio Meter
PIP H/V Delay Waveform
Please refer to the individual menu pages above for details about these
functions.
USER FUNCTION SHORT CUT (F1 – F4) MENU
The monitor front panel has four special function keys marked F1 through F4.
These are pre-programmed as short cuts keys per this table:
FUNCTION KEY STANDARD SHORT CUTS
F1 Peaking
F2 Waveform / Vector
F3 Audio Bars & Phase Scope
F4 Histogram
These function keys may be re-programmed at any time by first pressing the
function key for about three seconds. The function key menu will appear at the
right side of the screen. Simply rotate the Menu knob to the desired function
short cut and press the Menu knob to make the selection.
One of the following shortcuts may be programmed to each function key:
OPTIONAL SHORT CUTS
Screen Marker Image Flip Peaking
Aspect Marker Zoom False Color
Check Field Pixel-to-Pixel Exposure
Color Bars Image Freeze Histogram
Aspect Ratio Underscan Audio Meter
PIP H/V Delay Waveform
Please refer to the individual menu pages above for details about these
functions.
The monitor front panel has four special function keys marked F1 through F4.
These are pre-programmed as short cuts keys per this table:
These function keys may be re-programmed at any time by rst pressing the function key for about
three seconds. The function key menu will appear at the right side of the screen. Simply rotate
the Menu knob to the desired function short cut and press the Menu knob to make the selection.
One of the following shortcuts may be programmed to each function key:
Please refer to the individual menu pages above for details about these functions.