Marshall Electronics Broadcast A/V Division M-LYNX-503 Triple 5” Rackmountable Monitor with HDMI, 3G-SDI and Composite Inputs Operating Instructions V.1.
Marshall Electronics M-LYNX-503 / Operating Instructions Connections, Power On and Initial Setup 1. OVERVIEW The M-LYNX-503 provides three independent wide-screen displays in only 2RU rack height and very slim 1.75” (44.5mm) depth. Each display has inputs for 3GSDI, HDMI and standard composite analog video sources. The SDI and HDMI digital inputs provide active loop-through connections while the composite input is self-terminating with passive loop-through.
Marshall Electronics Plug the included power supply into an AC power source (100 – 240 Volts @ 50/60 Hz). Attach the power connector to the back of the monitor. (Alternatively, a standard camera-type 12-volt power supply with an XLR-4 connector may be used). Connect the required cables for video signal input and output. The monitor defaults to “ON” when power is connected. The Marshall name will first appear then video will be automatically detected and displayed on the screen.
Marshall Electronics No Signal: Select the color background that appears when there is no video input. OSD Trans: Adjust whether On Screen Display text is transparent. OSD H: Adjust horizontal position of On Screen Display text. OSD V: Adjust vertical position of On Screen Display text. Zoom All: Expands the picture on the screen in all directions by pressing the ► button Normal (default) setting is “0”. OSD Time: Set the number of seconds text messages will remain on the screen.
Warranty Marshall Electronics warranties to the first consumer that this M-LYNX-503 triple 5” rackmountable monitor will, under normal use, be free from defects in workmanship and materials, when received in its original container, for a period of one year from the purchase date. This warranty is extended to the first consumer only, and proof of purchase is necessary to honor the warranty.
