Broadcast A / V Division CV503, CV506, CV344, CV346 Compact & Miniature Full-HD Cameras User Manual
CV503/CV506/CV344/CV346 Manual 1. General Information Thank you for your purchase of a Marshall Miniature or Compact Camera. Table of Contents The Marshall Camera team recommends thoroughly reading this guide for a deep understanding of on-screen-display (OSD) menus, breakout cable operation, settings adjustment explanation, troubleshooting, and other critical information. Table of Contents 01 1. General Information 02 2. Menu Structure 03 3. OSD Joystick and Button 05 • • • 4.
CV503/CV506/CV344/CV346 Manual 2.
CV503/CV506/CV344/CV346 Manual 3. OSD Joystick and Button 4. WB CONTROL 2 U 4 L 1 R 5 D 3 503 506 Select WB CONTROL using the UP or DOWN button. You can change between AUTO, ATW, PUSH, and MANUAL using the LEFT or RIGHT buttons. • ATW: Continuously adjusts camera color balance in accordance with any change in color temperature. Compensates for color temperature changes within the range of 1,900°K to 11,000°K. • ONE PUSH: Color temperature will be manually adjusted by pushing the OSD button.
CV503/CV506/CV344/CV346 Manual 5. AE CONTROL 6. DAY / NIGHT Select AE CONTROL using the UP or DOWN button. You can select one sub-mode using the UP or DOWN buttons. Select DAY / NIGHT using the UP or DOWN button. You can select one sub-mode from AUTO, COLOR, and NIGHT using the UP or DOWN buttons. MODE: Set camera to either color mode or B&W mode.
CV503/CV506/CV344/CV346 Manual 7. AUDIO 8. IMAGE CONTROL Select AUDIO using the UP or DOWN button and enter ON using SEL button. You can select one sub-mode using the UP or DOWN buttons. Select IMAGE CONTROL using the UP or DOWN button. You can select LENS SHADING, CONTRAST, HUE, And EDGE ENHANCE using the UP or DOWN buttons. • MIC / LINE: Select MIC or LINE for the audio input source. • AUDIO LEVEL: Select this to adjust audio levels manually.
CV503/CV506/CV344/CV346 Manual 9. SPECIAL 10. SETUP Select SPECIAL using the UP or DOWN button. You can select DEFOG, MOTION DETECT, BACKLIGHT, DEFECT PIXEL, and FLICKER DETECT using the UP or DOWN buttons.
CV503/CV506/CV344/CV346 Manual 11. RESET 12. EXIT Select RESET using the UP or DOWN buttons. Select EXIT using the UP or DOWN button. • RESET: Reset the camera settings the factory defaults or user setting value.
Warranty 13. TROUBLESHOOTING Before sending the camera for repair, please check below to make sure that the camera is installed correctly. If it still does not perform adequately, please consult with your supplier. Problem Nothing appears on the screen. Solutions a. Check that all connected devices are powered on. b. Confirm that the voltage is correct. c. Confirm that the power supply provides enough current to power the camera. d. Check that all video cables are correctly connected.
