Technical data
CHAP-04.10 ELECTRICAL POWER DISTRIBUTION, DRIVES, CONTROL &
ILLUMINATION ELECTRICAL
Page 24 of 50
existing drives (to be upgraded as per technological requirements) for
integrated operation of the overall CHP, CSP, and FFP with respective
existing/new units as shown in configuration diagram and elsewhere.
The approval / clearance of BSP / their representative will be taken
before carrying out new installation for up gradation for existing
conveyors / equipment.
For the EMPLOYER’s approval / clearance, Contractor will submit
detailed shut down plan of the existing drives indicating temporary
arrangement to be made by the Contractor for running suitable
alternative conveying routes so that plant can maintain production level.
In the temporary arrangement in case any electrics is required, the same
will be provided by the Contractor without any price implication.
Scope of work:
Except MCC, Contractor will dismantle existing motor, LCS, safety
and limit switches, associated power and control cables, Jn. Boxes,
earth wire, GI strip etc. related to the particular drives. The same will
be removed from site to facilitate new installation as per requirement
of TS and GTS and for running the equipment.
Contractor will provide complete new electrics including motor,
suitable intelligent type motor feeder in MCCs/MCPs, brake panels,
all safety and limit switches, local control station (LCS), Junction
boxes, necessary hardware and software for PLC based automation
(including power supply, input, output and communication cards etc.)
all power, control and signal cables, earthing.
04.10.12. ELECTRICS AND AUTOMATION FOR ADDITIONAL FLUX AND FUEL
CRUSHING AND FINES HANDLING SYSTEM
All the equipments for this facility will be new.
04.10.13. TECHNICAL SPECIFICATION
04.10.13.01. General
GTS will be referred for technical specification of various electrical
equipment. However for specific application following TS will be
considered.
04.10.13.02. Non intelligent type Control Panel
01. Control panel for Tripper car, crane, hoist and small machine will
have conventional non draw-out type and mounted on anti vibration