Technical data

CHAP-04.09 INSTRUMENTATION & CONTROL
Page 5 of 15
be provided. These signals will also be hooked up with the automation
system for alarms and necessary interlocks.
B) Coke Sorting Plant:
The measurements for Coke Sorting Plant will include, but not limited to,
the following:
i. Level measurement of bunkers (4 nos.): For each bunker one no. of
level transmitter (radar type) and one no. of high level switch will be
provided. These signals will also be hooked up with the automation
system for alarms and necessary interlocks.
C) Fuel & Flux Crushing & Screening system:
The measurements for Fuel & Flux Crushing & Screening system will
include, but not limited to, the following:
i. Level measurement of bunkers (6 nos.): For each bunker one no. of
level transmitter (radar type) and one no. of high level switch will be
provided. These signals will also be hooked up with the automation
system for alarms and necessary interlocks.
ii. Level measurement of bunkers (1 no.): For this bunker two nos. of level
transmitters (radar type) and two nos. of high level switches will be
provided. These signals will also be hooked up with the automation
system for alarms and necessary interlocks.
04.09. 04. LIST OF DRAWINGS & DOCUMENTS
Following drawings and documents will be submitted by the Contractor for
Instrumentation system:
I) For Approval :
01. Finalised process and instrumentation (P & I) diagram indicating all local &
remote measurements, alarms and interlock functions, using ISA symbols
and using suitable tag numbers against each instrumentation equipment.
02. Finalised list of measurements, alarms & interlocks, along with BOQ and
document of each instrumentation item indicating make, model number,
scale range, quantity, application and tag number (as per P&I diagram).
03. Detailed specification datasheet for each instrumentation item, filled in as
per the format finalized for this plant.
04. Overall general arrangement drawings & sectional views of various
cabinets, panels, consoles, etc., showing internal disposition of all
components/ units, with dimensional details and bill of materials.