Technical data

CHAP-04.11 AUTOMATION
Page 9 of 15
12. Fully wired cabinets/ panels, etc with MCBs, Fuses, CFL Lamps,
Universal type service sockets, Earth strips, etc.
13. Control room furniture for CSP dispatcher
14. In existing Control Room/Dispatcher –CR1 of Augmentation in Flux -
Fuel Preparation and Plant Return Fines Handling for SP III, existing
4 monitors will be replaced by new TFT monitor of size 22”, identical
to new monitors for aesthetic looks.
15. Submission of drawings and documents as per mentioned at clause
no. 06.11.05 of this CS.
16. a) In the automation system for CHP, few facilities from Pkg-062 are
proposed to be used. These facilities include Fault-tolerant HMI
server, Fault-tolerant history and process support server, Fault-
tolerant MIS server, Network at Despatcher-D2, etc. Contactor will be
responsible for all necessary activities, including coordination, with
the supplier of Pkg-062 towards licensing requirements, development
of application for Pkg-064, deployment of clients, network etc.
b) Erection, testing, calibration and commissioning of the total
Automation equipment / system of CHP, CSP and FFP included in
this specification. Required interfacing with employer’s PLCs by
providing necessary hardware and software and interconnecting
cables. This will also include laying and termination of system bus
cables as required.
17. Contactor will arrange tools, tackles and consumables as may be
required for erection, testing, calibration and commissioning
activities.
18. Contactor will arrange inspection of Automation equipment by
Employer/ Consultant. Inspection and Testing will be carried out in
compliance with the Quality Assurance Plans and FAT document, to
be approved during detailed engineering stage.
19. Contactor will arrange visit by respective Automation manufacturer’s
representatives at site, as & when required, during erection &
commissioning.
20. Testing tools & equipment for automation system
21. Special tools will be provided in sufficient number for tracing, location,
testing, jointing, fault location & rectification, termination etc. for all
cables including special cables.