User Manual

8
40974 Rev. 08-25-2015
Filling the Water Bottle – Figure 4
1. Remove the water bottle from the machine.
2. Remove the duckbill valve from the water bottle.
3. Fill the water bottle with water.
4. Place the duckbill valve back into the water bottle.
5. Place the water bottle back onto the machine; verify that the post in the brush tank is
inserted through the duckbill valve.
Figure 5 – Adjustable Water Level Positions
Adjusting the Brush Tank Water Level – Figure 4 & 5
1. Loosen the retaining screws on the water bottle brackets.
2. Move the water bottle brackets to the desired position to obtain the desired water level in
the brush tank, light weight tapes would typically be set at the low position, Figure 5.
3. Both brackets should be at the same position.
4. Tighten the retaining screws on the water bottle brackets.
Adjusting the Tape Weight – Figure 4
1. Loosen the retaining screw.
2. Slide the tape weight forward for greater pressure, typically heavy weight tapes which
will apply more water on the tape.
3. Slide the tape weight backwards less pressure, typically light weight tapes which will
apply less water on the tape.
4. Tighten the retaining screw.
High
Medium
Low
Water Bottle
Bracke
t