Owner`s manual

get into it!
Use the TEMP+- pad to scroll through filter cycle
options. When desired selection has been
reached, press the SETTINGS pad to enter selec-
tion and advance to the Smart Logic™ settings.
Selectable filter cycles and cycle duration
• 2C: twice per day (once every 12 hours)
• 1d: once during the day
• 1n: once during the night
• F1: 45 minutes
• F2: 2 hours
• F4: 4 hours
• F6: 6 hours
SMART LOGIC™
Since a spa is always covered when not in use, it
stays fairly free of debris or outside contamination.
Contamination to a spa’s water occurs during
usage, so filtering immediately after usage is the
most effective time to clean the spa water. Your
spa is preset at the factory with a default setting to
filter for one hour (1H) every time your spa is used.
This filtration cycle begins 30 minutes after the spa
light or jet pump has been deactivated. The pump
runs on low-speed to filter the water for the cycle’s
duration.
Selectable Smart Logic Settings
• 1H: 1 hour
• 2H: 2 hours
• 3H: 3 hours
• 4H: 4 hours
• OH: Off
To adjust the Smart Logic settings:
Use the TEMP+- pad to scroll through options. When
desired selection has been reached. Press SET-
TINGS pad to enter selection and exit settings mode.
TEMPERATURE DISPLAY AND ADJUSTMENT
Factory Default Settings:
• Temperature: 102°F (39°C)
The LCD window displays the actual water tem-
perature. Pressing the TEMP+- pad makes the
numbers flash, then pressing the pad again (re-
peatedly) increases the set temperature one
degree at a time, up to 104°F (40°C). After a short
TEMP+-
SETTINGS
spa control operation
TEMP+-
SETTINGS
22