Owner`s manual

INSTALLATION INSTRUCTIONS

MARQUIS SPAS • RELAXING YOUR WORLD 9

7. Remove the black cap from the barbed fitting suspended above the equipment

(some water may drip from this fitting, have a towel handy).

8. Place the exposed tubing end on the 1/4" barb.

9. There is a labeled mounting block attached to the spa which shows the

mounting position of ozonator.

CAUTION: DO NOT PREDRILL SCREW HOLES.

10. Turn on the power to the spa. You will see the ozonators blue light turn on and

bubbles come out of the single ozone jet in the spa with the primary pump on

low-speed operation.

11. Close the equipment door.

ELECTRICAL REQUIREMENTS

It is the responsibility of the spa owner to ensure that all electrical connections are made

in accordance with all electric codes in effect at the time of installation.

240 Volt:

All connections must be made in accordance with the wiring diagram found on the

inside of the control box cover. Connections should be made with copper conductors

only  aluminum wiring should not

be used with this system. All

conductors, circuit breakers, and/or

fuses must be sized in accordance to

the Total Amperage Load as

specified:

 Permanently connected

 Rated 240V, 60Hz, 50A, three

wires plus ground (6 AWG

copper)

 Fuse or circuitbreaker size: 50 amp

This equipment is designed to

operate on 60Hz Alternating

Current only at a voltage of 240.

Units to be operated at 240V must

have all connections made by a

qualified electrician in accordance

with any electric codes in effect at

the time of installation. All 240V

units require a three wire plus ground (line 1, line 2, neutral, ground). Refer to the

label at the terminal block.

A pressure wire connector is located on the exterior of the control box. If the

installation includes a common bonding grid (reinforced concrete slab, ground plate

beneath the spa, or any metal water pipe connection), this pressure wire connector

should be bonded, with at least #8 AWG (8.42mm

, #6 in Canada) copper wire, to

any metal ladder, water pipe, or other metal, within five feet of the spa.

(CONTINUED)