Owner`s manual

9. The system requires approximately two minutes
of water flow to determine the water tempera-
ture. After two minutes of water flow, the tem-
perature is displayed as actual water tempera-
ture. After you have manually exited the priming
mode (or allowed the spa to automatically exit)
the LCD window momentarily displays 102°F
(39°C) and then the display switches to - - °F.
10. The factory default setting for water tempera-
ture is 102°F (39°C). Use the TEMP pad on the
control panel to set the water temperature to
the desired level. (See SPA CONTROL OPERA-
TION, Temperature Display And Adjustment.)
Your spa heats at the rate of approximately
five degrees per hour for 240V systems.
DURACOVER
When the spa is not in use, the DuraCover should
be kept on the spa to retain the water’s heat and to
keep out dirt, leaves, etc. Your heater maintains a
constant water temperature between uses.
For your safety and convenience, the cover is
equipped with adjustable straps, safety locks, and
handles. Use the exterior handles to remove and
replace your cover. Marquis suggests that you use
the safety locks to help keep out unintended users
and prevent covers from being blown off in windy
conditions. For high wind areas, Secure Straps (part
#8140) are available. DuraLift (part #8225) cover lifts
are also available to assist you in cover removal.
(See SPA ENHANCEMENTS at back of this manual.)
PAGE 17
starting your spa
MARQUIS SPAS
Use TEMP pad to set
water temperature.
DuraCover helps
maintain a constant
water temperature.