Owner`s manual

marquis care and enjoyment guide

PAGE 53

MARQUIS SPAS

BUILT-IN SANITATION SYSTEM*

After shocking the spa water with Chlorine Sanitizer

granuals or non-chlorine Spa Shock, bring the spa

water to operating temperature. Then install the Spa

Frog

cartridges.

ADJUST THE MINERAL CARTRIDGE*

Remove the protective cellophane wrap from the

Spa Frog

mineral cartridge. While holding the bottom

of the cartridge, turn the top until the number six

appears in the setting window.

NOTE: The mineral cartridge should be replaced

every three to four months. You will still feel the

“spent” minerals inside, but they are no longer

effective and the cartridge needs to be replaced. It is

recommended to drain and refill the spa at the same

time you replace the mineral cartridge.

ADJUST THE BROMINE CARTRIDGE*

Remove the protective cellophane wrap from the

Spa Frog

bromine cartridge. Finding the right setting

for the bromine cartridge will require monitoring your

usage for the first few weeks. Begin with an initial

setting based on the chart below and monitor

bromine levels daily for the first week or so, adjusting

the cartridge by one setting per day until a 1 - 2 ppm

level has been achieved. To adjust cartridge, remove

from system and turn to the next highest setting if

the bromine level is low, or the next lower setting if

the bromine level is high. The bromine cartridge

needs to be replaced when empty between two and

four weeks. Always maintain 1 - 2 ppm of bromine.

Suggested Initial Bromine Cartridge Settings

Daily filter time Spa Gallons

250-300 300-400 400-500

One hour 2 3 4

Two hours 2 2 3

Four hours 1 2 2

Setting

Window

Install cartridges in the

holder.