Owner`s manual

PERSONAL SAFETY DOs:
Be sure your spa is connected to the power supply correctly – only use
a licensed electrical contractor.
Shut off power supply (unplug 120V models) before draining the spa
or servicing the electrical components.
Test the Ground Fault Circuit Interrupter (GFCI) monthly.
Always test the water temperature with an accurate thermometer
before entering the spa to be sure that it’s a safe temperature.
Remember that wet surfaces can be very slippery. Take care when
entering and exiting the spa.
Lock the DuraCover when the spa is not in use, whether it is empty or
full of water.
Keep the water clean and sanitized with correct chemical care.
Turn on the jets when adding ANY chemicals to the spa water.
Clean the filter cartridge(s) monthly to remove debris and mineral
buildup which affects the performance of the hydrotherapy jets,
limits the flow, or trips the high limit thermostat which will turn off the
entire spa.
PERSONAL SAFETY DO NOTs:
Don’t use the spa with the equipment compartment door removed.
Don’t use the spa for more than 10 minutes of time at water tempera-
tures in excess of 102°F (39°C).
Don’t allow the jet pump(s) to operate for an extended period of time
with the cover in place. Extended pump operation causes a slow
heat buildup due to water friction. The spa equipment controls are
equipped with a built-in safety timer that automatically shuts off the
jet pump(s) after 15 minutes of continuous operation should it have
been left on inadvertently.
Don’t operate the spa at any time with the filter cartridges removed.
Don’t lift or drag the cover by using the tie-down straps; always lift and
carry by using the external handles.
Don’t store chemicals in the spa’s equipment compartment.
Don’t hesitate to call your Marquis Spas dealer with any questions or
maintenance concerns.
PAGE 9
safety instructions
MARQUIS SPAS