Owner`s manual

OUTDOOR AND PATIO INSTALLATION
To install the spa outdoors, we recommend a
reinforced concrete pad at least four inches thick.
The reinforcing material should be attached to a #8
AWG bonding wire per national and local
electrical code.
If you place the spa on the ground, even tempo-
rarily, place concrete pavers under the entire bottom
of the spa. The concrete pavers should be a least
two inches thick and level across the entire surface.
The spa will inevitably settle and not remain level on
this surface, thus it’s important to get it onto a solid
foundation as soon as possible.
DECK INSTALLATION
Be sure the deck can support the weight of your
filled spa by checking the deck’s maximum load
capacity. Consult a qualified building contractor or
structural engineer. Minimum requirement is 100
pounds per square foot.
INDOOR INSTALLATION
There are special requirements if you place your spa
indoors. Flooring material must provide adequate
traction when wet. Proper drainage is essential to
prevent water puddling. Proper ventilation to the area
is required. The addition of a ventilation system is
recommended. Please see your contractor for
details.
PAGE 11
installation instructions
MARQUIS SPAS