Operation Manual

GB-4
POWER SOURCE
REMOTE BATTERY INSTALLATION
1. Remove the Battery Compartment
(on the bottom rear of the remote
control) by sliding the compartment
out. (You can insert a penny, or similar
object, into the groove on the
compartment to help slide it out.)
2. Install a CR2025 battery, paying
attention to the polarity diagram in the
Battery Compartment (positive side up).
3. Replace the Battery Compartment.
BATTERY PRECAUTIONS
Follow these precautions when using a battery in this device:
1. Use only the size and type of battery specified.
2. Be sure to follow the correct polarity when installing the battery as
indicated in the Battery Compartment. A reversed battery may cause
damage to the device.
3. If the device is not to be used for a long period of time, remove the
battery to prevent damage or injury from possible battery leakage.
4. Do not try to recharge a battery not intended to be recharged; it can
overheat and rupture. (Follow battery manufacturer’s directions.)