Operation Manual

GB 3
Power supply
Insert the small end of the AC adapter into the USB jack, connect the other end
to a wall outlet.
Note:
z Remove both the DC plug and the USB plug to disconnect the AC
adapter when not in use.
z Only use the supplied AC adapter which has the following spec: USB 5V
Power on/off
1. Power on the unit automatically as soon as the power supplied.
2. Power off the unit when holding the /exit button for a long time.
Setting time and date
1. Press the /exit button: the menu appears.
2. Use the  or  button to highlight “CALENDAR”, then press the enter
button: the clock interface appears.
3. Repeat press / setup button to flicker among the field of “year”, “month”,
“day”, “hour”, “minute”, “second”, “alarm state”, “hour of alarm time”,
“minute of alarm time”.
4. Press  or  button to set the values.
5. After finishing the setting, press enter button to exit the setup state.
Setting/Activating alarm time
1. Repeat press / setup button to flicker the field of “alarm state”.
2. Press  or  button to make the alarm activated or not. When alarm is
activated, ‘ ’ displays. When alarm is not activated, ‘ ’ displays.
3. Repeat press / setup button to flicker the field of “hour of alarm time”,
press  or  button to set hour.
4. Repeat press / setup button to flicker the field of “minute of alarm time”,
press  or  button to set minute.
Switching off the alarm
During alarm call, press any button to switch off the alarm. Alarm will auto reset
daily.
Helpful hint:
z During alarm call, if no button be pressed, alarm call will last 5 minutes.
Using USB cable to connect the unit to PC
1. Insert one end of a USB cable to PC, the other end to the USB jack of the
unit, the unit will be powered on after 3 seconds, then display the
slideshow of the stored picture. Press /exit button for the first time, the