Operation Manual

IMPORTANT INFORMATION

． Playing CD’s at higher volume levels increases the battery drain and

shortens the battery life. Try to use AC adaptor whenever it is available.

． We recommend using alkaline batteries for the longest possible life.

． Change the batteries when the output of the unit becomes weak or the

sound becomes distorted. Always change all eight (8) batteries at the same

time.

． If the unit will be stored and not used for 30 days or more it is recommended

to remove the batteries from the battery compartment to reduce the

possibility of damage from battery leakage or corrosion.

STEREO HEADPHONE JACK

For private listening without disturbing others, connect a set of stereo

headphones (not included) to the HEADPHONE Jack. The built-in speakers

automatically shut off when stereo headphones are connected to the

HEADPHONE Jack. When using stereo headphones always start with the

volume control set to a low level and gradually increase until you find the desired

level.

EXTERNAL MIC JACK

Plug in an external microphone , set the FUNCTION SELECTOR to ‘CD’ or ‘AUX’.

The sound is amplified by the built-in amplifier. Set the desired volume by MIC

VOLUME control. Set the echo effect by ECHO VOLUME control. (external

microphone is included).

NOTES:

* Unplug microphone not in use to avoid noise.

* In case of microphone not howling, operate as follows.

1) Put the microphone away from the speakers.

2) Lower the microphone volume

3) Change the microphone direction so as not face the speakers.

4) Reduce the echo level.

BATTERY PRECAUTIONS

Follow these precautions when using batteries in this device:

1. Use only the size and type of batteries specified.

2. Be sure to follow the correct polarity when installing the batteries as indicated in the battery

compartment. Reversed batteries may cause damage to the device.

3. Do not mix different types of batteries together (e.g. Alkaline and Carbon-Zinc) or old

batteries with fresh ones.

4. If the device is not to be used for a long period of time, remove the batteries to prevent

damage or injury from possible battery leakage.

5. Do not try to recharge batteries not intended to be recharge; they can overheat and rupture.

(Follow battery manufacturer’s directions.)