Operation Manual

Bijlage
56
Troubleshooting
1. The screen is blank after you press the POWER keypad.
Wrong batteries installation or no enough power. Check to insure
that the batteries are installed correctly and that the battery terminals
are clean. Or replace the batteries.
It may because you did not make valid operation (press is too
light to start). Please press POWER key again till the unit responses
and hear a sound B and see the welcome page.
If you hear a sound B, then the unit is already turned on. You need
to adjust screen contrast until you can recognize the words on the screen.
Please take a reference in page 37 on Turning on.
2. Battery choices
You can use alkaline battery or rechargeable battery. But if you use
rechargeable battery, the unit can not show you the correct information
on the batteries condition.
3. Unavailability of satellite signals for long time
Make sure you are operating outdoors, not in a house or building.
See if the sky is clear and open, it will influence the satellite signals
reception.
Check your surroundings, there may be some electric or magnetic
field around you or the unit which can interfere the normal work,
such as wireless radio station, radio tower or high-voltage wires and
cables, and etc.
4. GPS handheld receiver has water outside and inside
Wipe down the water outside of the unit with clean clothing. Put
it in a windy place without direct sunshine and dry the inside. Then
try to turn it on again to see if it works well. If it is still not good,
please contact local maintenance agency. Never try to open the unit
by yourself.
5. Though in open area with clear sky, GPS handheld receiver can not
track satellite.
It may because GPS handheld receiver had worked indoor for long time and
been brought outdoor directly. Please turn off out door and restart it.
The GPS handheld receiver is damaged. Please contact local dealer
or supplier.
6. Fell down or collided
Check the appearance completeness. Contact the local maintenance agency if
you find the unit does not work well.