Operation Manual

Destinator 27
Search for a Location
Setting Stops Along the Route
You can set up stops by selecting the Route Group and tapping the Next button. From the Stops screen, tap
the Actions button to add, rename, or delete a destination.
Add a stop by Address, POI, My Favourites, or Recent Locations. Select one of these options, and specify a
location. The selected location appears in the Stops screen.
Figure 31 - Specifying a Stop
When in the Stops screen, you can use the following commands:
Use the Up or Down buttons to change the order of your itinerary.
Shows the stop destination on the map and lets you select a route type, Quick or
Short. Tap GO to calculate the stop destination.
Select the Show button to view the selected stop destination on the map.
Stops Actions
You can tap the Actions button for the following command options:
Set as Origin
Lets you designate the selected address as the route origin. You would use this
command when calculating a route from a point other than your current location.
Note: You are still connected to the GPS signal.
Add Stop
Lets you add a location by specifying an address from recent locations, favourite
locations, or pre-defined POIs, such as fuel, food, or lodging.
Rename Stop
Lets you change the stop information, such as name, comments, or route group.
Delete Stop
Lets you remove a selected stop.