Operation Manual

Destinator 13
Search for a Location
Postcode T
his sequence provides the following address screens: Zip Code, Street, Address
Number
You can locate a street address by entering the post code, without entering a town
name. Useful when you have no information about the town.
Address Actions
When you have specified an address, tap the Actions button to select from the following Address commands:
Set as Origin
Lets you designate the selected location as the route origin. You would use this command when calculating a
route from a point other than your current location.
Show on Map
Lets you see the selected address on the map.
Add to My Favourites
Lets you add an address to your list of favourite locations, as shown in the figure below. For more information,
see "My Favourites".
Figure 15 - Add Address to My Favourites
Information
Displays the location’s address information.
Go to your Destination
After you have specified the address, tap the Next button. Destinator shows your destination on the Map
screen before calculating a route. Check that the destination address is correct at the top of the screen. If you
want to change the destination, tap the Back button and change your address entries.
Figure 16 - Calculate your Destination
When you have specified the address, you can instruct Destinator how to calculate your route by tapping
either the Quick or Short button.