Operation Manual

• ‘SEARCHING’ and the symbol appear on the display.

• The RFPI code (each base unit has a unique RFPI code) appears on the display and a signal

sounds once the base unit is found by the handset.

• Press the Programming key .

• ‘PIN’ appears on the display.

• Enter the 4-digit PIN code of the base unit (default PIN code is ‘1590’). Use the number keypad.

• Press the Programming key .

• The handset is subscribed to the base unit.

HANDL. B2405_10.qxd 24/4/02 4:30 pm Pagina 21

MDECT-1

ENGLISH

4.26 Removing subscription of a handset to a base unit

It is possible to cancel subscription of a handset to a base unit. You would do this if a

handset is damaged and has to be replaced by a new one.

Caution: You can only cancel subscription of another handset, not the handset you are using to do the

cancellation procedure.

• Press the Programming key .

• Press the Up or Down key repeatedly until ‘SETTING’ appears on the display.

• Press the Programming key .

• Press the Up or Down key repeatedly until ‘REMOVE HS’ appears on the display.

• Press the Programming key .

• ‘PIN’ appears on the display.

• Enter your 4-digit PIN code in (default PIN code is ‘0000’). Use the number keypad.

• Press the Programming key .

• ‘REMOVE HS’ appears on the display.

• Dial the number of the handset you want to remove (1 –5). Use the number keypad.

• Press the Programming key .

• ‘REMOVE HS’ appears on the display and the handset is removed

• NOT SUB’ appears on the handset removed.