Operation Manual

66
2525
1.6 Description of the Face of the Front Panel
1. STANDBY BUTTON 10. |<< BUTTON 18. PLAY/PAUSE BUTTON
2. MUTE BUTTON 11. ^ BUTTON 19. STOP BUTTON
3. MODE BUTTON 12. V BUTTON 20. MENU BUTTON
4. OK BUTTON 13. TILT BUTTON 21. RELEASE BUTTON
5. VOL KNOB 14. OPEN BUTTON 22. RESET BUTTON
6. BAND BUTTON 15. AF BUTTON 23. AUX INPUT SOCKET
7. >> BUTTON 16. TA BUTTON 24. IR REMOTE SENSOR
8. << BUTTON 17. NUMBER(1-6) 25. SMALL MONITOR
9. >>| BUTTON BUTTON
1.7 Description of the Unit Chassis Facet After Removing the Front Panel
26 PIN FEMALE CONNECTOR
TAMPON-PICK
LED
1. LED indicator: Flashing when detachable panel is removed.
2. 26 PIN FEMALE CONNECTOR: when there is some dirt on the connector,
please wipe it away from the connector.
1.8 Description of the Unit Chassis Facet After Sliding Down the Front Panel
LED indicators
* The LED indicators light all the time, they can help you operate during darkness.
4) Language Video Audio Rating
Password
Rating
Load Factory
PASSWORD
This setup item is for locking or unlocking the rating level of the Parental
Control.
The defaulted state is .
You can set a new password that you like:
(1) Select the PASSWORD item .
(2) nput a new password that you
like and then press the ENTER button to make it effective.
Before the other persons see the Manual, you should get the
password in mind and cut out the in the Manual.
.
RATING
The item is for setting a new rating level of the Parental Control.
(1) Select the PASSWORD item, then input the password mentioned above,
and then press the OK or ENTER button to unlock the setting of the rating
level of the Parental Control.
(2) Select the RATING item, then press the OK or ENTER button repeatedly
to change the rating level of the Parental Control .
(3) Select the PASSWORD item again, then input the password, and then
press the OK or ENTER button to lock the new setting of the rating level of
the Parental Control.
Load Factory
This item is for making the values of all setup items set by you change back
to the original status set by the factory.
3. After entering a desired setting page, use direction buttons to select a
desired setting item, then press OK or ENTER button to enter it.
4. After entering a desired setting item, use direction buttons to select a
desired mode and press OK or ENTER button to confirm it.
open
and then press the 0~9 button to enter it
Press the 0~9 button to enter it again, then i
super
super password
If you forget the password, input the permanent super password 8888