Operation Manual

INSTALLATION
5. Mount the sleeve by inserting the sleeve into th
e
opening of the dashboard and bend open the
tabs located around the sleeve with a
screwdriver. Not all tabs will be able to make
contact, so examine which ones will be most
effective. Bending open the appropriate tabs
behind the dashboard to secure the sleeve in
place.
(1) Dashboard (2) Taps
6. Reconnect the wire harness and the antenna
and be careful not to pinch any wires or cables.
7. Slide the unit into the sleeve until it locks in
to
place.
8. To further secure the unit, use the supplied
metal strap to secure the back of the unit in
place. Use the supplied hardware (Hex Nut
(M5mm) and Spring Washer) to attach one end
of the strap to the mounting bolt on the back of
the unit. If necessary, bend the metal strap to fit
your vehicle’s mounting area. Then use the
supplied hardware (Tapping Screw and Plain
Washer) to attach the other end of metal strap to
a solid metal part of the vehicle under the
dashboard. This strap also helps ensure proper
electrical grounding of the unit.
Note to install the short threading terminal of the
mounting bolt to the back of the unit and the other
long threading terminal to the dashboard.
(1) Metal Strap; (2) Mounting Bolt; (3) Hex Nut;
(4) Spring Washer; (5) Tapping Screw;
(6) Plain Washer
9. Reconnect the cable to the vehicle battery’s
negative (-) terminal. Then replace the out trim
ring.
Removing the unit
1. Make sure the ignition is turned off, then
disconnect the cable from the vehicle battery’s
negative (-) terminal.
2. Remove the metal strap attached the back of the
unit (if attached).
3. Lift the top of the outer trim ring then pull it
out to
remove it.
4. Remove the four screws on the left and the right
side of the unit then pull the unit out of the
dashboard.
8