Operation Manual

INSTALLATION
Notes:

Choose the mounting location where the unit
will not interfere with the normal driving function
of the driver.
 Before finally installing the unit, connect the
wiring temporarily and make sure it is all
connected up properly and the unit and the
system work properly.

Use only the parts included with the unit to
ensure proper installation. The use of
unauthorized parts can cause malfunctions.

Consult with your nearest dealer if installation
requires the drilling of holes or other
modifications of the vehicle.

Install the unit where it does not get in the
driver’s way and cannot injure the passenger if
there is an emergency stop.

If installation angel exceeds 30°from horizontal,
the unit might not give its optimum
performance.

Avoid installing the unit where it would be
subject to high temperature, such as from direct
sunlight, or from hot air, from the heater, or
where it would be subject to dust, dirt or
excessive vibration.
DIN FRONT/REAR-MOUNT
This unit can be properly installed either from
“Front”(conventional DIN Front-mount) or
“Rear”(DIN Rear-mount installation, utilizing
threaded screw holes at the sides of the unit
chassis). For details, refer to the following illus
trated
installation methods.
TAKE OUT SCREW BEFORE INSTALLATION
Before install the unit, please remove the two
screws.
DIN FRONT-MOUNT (Method A)
Installation Opening
This unit can be installed in any dashboard having
an opening as shown below:
Installing the unit
Be sure you test all connections first, and then
follow these steps to install the unit.
1. Make sure the ignition is turned off, and then
disconnect the cable from the vehicle battery’s
negative (-) terminal.
2. Disconnect the wire harness and the antenna.
3. Lift the top of the outer trim ring then pull it
out to
remove it.
4. Use the screwdriver to remove the four screws
on the left and the right side of the unit then you
can remove the sleeve.
30
Take out screw
before installation.
Sleeve
Screws
Outer Trim Ring
Unit
Screwdriver
7