Operation Manual

OWNER'S MANUAL
Detachable Front Panel
FM/AM Radio
Digital Volume
Electronic Anti-Shock System
RDS-EON Tuning System
Auxiliary Input
MCR-1255
GB-1
034139
e
11
LOCATION OF CONTROLS
3. PRE-SCAN/AUTO-STORE BUTTON / REPEAT CONTROL
On radio mode, this button allows you to enjoy “Preset Memory Scan” function by pushing it shortly, and “Auto-Store
Memory” function by pushing it more than 2 seconds.
lPS (PRESET MEMORY SCAN) - It calls the memorized station frequencies (from 1-6) automatically every 5 seconds.
lAS (AUTO-STORE MEMORY) - It searches all station frequencies upward and memorize automatically 6 stations by
catching the frequency which has scan-stop level, the memorized station is shown on LCD as “Channel 1 to 6”. After
memorizing, auto-store memory function will be changed to “Preset Memory Scan” function automatically.
REM
ARK:
AT ANY TIME
, IF THE WIRE H
AS B
EEN
DISC
ONN
ECTED, THE RE
SET BUTT
ON MUST
BE NEED
TO RE
SET AGA
IN BE
FORE
OPER
ATE THE RADIO (
REFER TO
RESE
T BU
TTON
FOR DETAI
LS). OTH
ERWISE, THE R
ADIO
MAY NO
T WORK P
ROPE
RLY.
OPERATING INSTRUCTIONS
1. POWER ON/OFF CONTROL
Press the button to turn the power “ON” or “OFF”.
Note : The unit can be turn on by pressing any keys on the panel (except panel release button). It will help the user who
cannot find the power button in dark.
4. LCD DIGITAL DISPLAY
The unit utilizes a digital type display which shows numerical indication of station FREQUENCY and other FUNCTIONS.
5. DISPLAY BUTTON
This button serves to show available information as following:
- Station Name
- Band and Frequency
- Time
- Programme Type Name
SETTING CLOCK TIME MANUALLY
1. Press “DISP” button and hold it until the display flash and release.
2. Rotate “VOL/SEL” button clockwise to set HOUR and anti-clockwise to set MINUTE.
2. BAND SELECTOR
On radio mode, each time this button is pressed, the radio band is changed. The indication “FM1”, “FM2”, “FM3”,
“MW1” or “MW2” will appear on the display according to your selection.
6. SCAN CONTROL
Press this button to scan the receivable FM / MW stations during radio mode. When receivable stations are tuned in, they
are monitored for approximately 5 seconds before advancing to the next receivable station. Press this button once again
to stop scanning as desired.
7. PANEL RELEASE BUTTON
This button is used to release the panel from the unit.
lTo detach the front panel, press the button so that the left side of the panel is released. Grasp the released side and
pull it off of the chassis (FIGURE A).
lTo re-attach the panel, insert the right side of the panel in place first and then press the left side of the panel until the
chassis hold the panel firmly (FIGURE B).
GB-2
FIGURE B
FIGURE A
(17)
RESET
AUX
PRESET
EQ
MOBILE RADIO
Spectrum
D
i
s
pl
a
y
1 3
PWR
65
BND
MOD
AUX
PRESET
EQ
MOBILE RADIO
Spectrum
D
i
s
p
l
ay
42
RDS
MCR-1255
Detachable
Front Panel
1 3
PWR
65
BND
MOD
AUX
PRESET
EQ
MOBILE RADIO
Spectrum
D
i
s
p
l
a
y
42
RDS
MCR-1255
Detachable
Front Panel
(14)
(4) (16)
(15) (1)(9)(11)(10)(6)(5)
(13)(2) (3)(8)(7)
(12)