Quickstart Guide English
Introduction Box Contents Ray Tracer X Quickstart Guide Power Cable Safety & Warranty Manual DMX Cable Important: Visit marqlighting.com to download the complete User Guide. Support For the latest information about this product (documentation, technical specifications, system requirements, compatibility information, etc.) and product registration, visit marqlighting.com. For additional product support, visit marqlighting.com/support.
Features Rear Panel 1 2 4 5 6 3 1. Power In: Use a standard power cable (included) to connect this input to a power outlet. 2. Fuse: This compartment holds the fuse. Before cleaning or replacing the fuse, disconnect Ray Tracer X from its power source. Use a screwdriver or other tool to remove the compartment (do not pull it out by the tab only). Replace the fuse only with a new fuse with the same rating (250 V, 5 A). 3.
Setup Note: Items not listed under the Introduction > Box Contents are sold separately. Power Information Before connecting the fixture to a power outlet, make sure the power cable is not crimped or damaged. Also, make sure the power outlet’s voltage is within the range stated on this product (on its housing or decal). Before cleaning or replacing the fuse, disconnect Ray Tracer X from its power source. Use a screwdriver or other tool to remove the compartment (do not pull it out by the tab only).
Linking When using multiple Ray Tracer X fixtures, you can link (“daisy-chain”) them so that each each fixture supplies power and/or sends DMX data to the next one. This helps reduce clutter in your cabling and save you setup time. You do not have to link fixtures for both power and DMX control; you can link them for either purpose independently.
Operation Menu Options Note: To return to the top menu from a submenu page, use the Up and Down buttons to select the Exit option at the bottom of the submenu, and then press Enter.
DMX Functions You can control Ray Tracer X by linking it to a DMX controller. Please see the complete User Guide at marqlighting.com to learn how to do this. See below for charts of available functions. 17-Channel Operation Channel Function Value Description 1 2 Pan 000–255 Pan angle, 0° (000) to 630° (255) Tilt 1 000–255 Tilt Motor 1, 0° (000) to 150° (255) 3 4 Tilt 2 000–255 Tilt Motor 2, 0° (000) to 150° (255) Dimmer 000–255 Dimmer, dark (000) to bright (255).
17-Channel Operation (continued) Channel Function 14 (cont.
17-Channel Operation (continued) Channel Function Value Description 17 Control Functions 000–069 No function All functions are executed after 2 seconds.
8-Channel Operation (continued) Channel Function Value Description 6 (cont.
Technical Specifications Specifications are subject to change without notice.
marqlighting.com Manual Version 1.
