User manual

Features

Rear Panel

1. Power In: Use a standard power

cable (included) to connect this

input to a power outlet.

2. Fuse: This compartment holds the

fuse. Before cleaning or replacing

the fuse, disconnect Gesture

Spot 500 from its power source.

Use a screwdriver or other tool to

remove the compartment (do not

pull it out by the tab only). Replace

the fuse only with a new fuse with

the same rating (250 V, 4 A).

3. Power Out: Use a standard power cable to connect this output to an additional fixture. This

connection will supply power to the additional fixture when this one is connected a power outlet.

Please see Setup > Linking > Power for information about linking multiple fixtures.

Note: On models sold in the USA, this will be a standard “Edison” (NEMA) connection. On other

models, this will be a standard IEC connection.

4. Power Switch: Use this switch to power Gesture Spot 500 on/off.

5. DMX In: Use a standard 3-pin DMX cable to connect this input (A) to your DMX controller or (B)

to another fixture that will pass DMX data through it to this one. Gesture Spot 500 receives DMX

data over this connection. Please see Setup > Linking > DMX for information about linking

multiple fixtures.

6. DMX Out: Use a standard 3-pin DMX cable to connect this output to an additional fixture.

Gesture Spot 500 sends its data to an additional fixture over this connection. Please see Setup >

Linking > DMX for information about linking multiple fixtures.

Front Panel

7. Display: This display shows

messages and values indicating

the fixture’s current status.

8. Menu: Press this button to access

Gesture Spot 500’s menu.

9. Up: Press this button to select the

next-highest menu option or to

increase the value by 1.

10. Down: Press this button to select

the next-lowest menu option or to

decrease the value by 1.

11. Enter: Press this to confirm your current selection or value.

12. DMX: This light will illuminate when Gesture Spot 500 is receiving DMX data properly through its

DMX In.

13. Error: This light will illuminate when Gesture Spot 500 receives an invalid DMX command.