User manual

3
Features
Rear Panel
1. Power In: Use a standard power
cable (included) to connect this
input to a power outlet.
2. Fuse: This compartment holds the
fuse. Before cleaning or replacing
the fuse, disconnect Gesture
Spot 300 from its power source.
Use a screwdriver or other tool to
remove the compartment (do not
pull it out by the tab only). Replace
the fuse only with a new fuse with
the same rating (250 V, 4 A).
3. DMX In: Use a standard 3-pin DMX cable to connect this input (A) to your DMX controller or (B)
to another fixture that will pass DMX data through it to this one. Gesture Spot 300 receives DMX
data over this connection. Please see Setup > Linking > DMX for information about linking
multiple fixtures.
4. DMX Out: Use a standard 3-pin DMX cable to connect this output to an additional fixture.
Gesture Spot 300 sends its data to an additional fixture over this connection. Please see Setup >
Linking > DMX for information about linking multiple fixtures.
Front Panel
5. Display: This display shows
messages and values indicating
the fixture’s current status.
6. Menu: Press this button to access
Gesture Spot 300’s menu.
7. Up: Press this button to select the
next-highest menu option or to
increase the value by 1.
8. Down: Press this button to select
the next-lowest menu option or to
decrease the value by 1.
9. Enter: Press this to confirm your current selection or value.
10. DMX: This light will illuminate when Gesture Spot 300 is receiving DMX data properly through its
DMX In.
11. Error: This light will illuminate when Gesture Spot 300 receives an invalid DMX command.
5
6
7
89
10
11
1
2
3
4