User manual

6. Test the operation of all the inputs

Programming per function

This chapter explains the actions that need to be performed to program the

module on the basis of function. See 3. Programming a function code for the

functions.

3.1 Sending On/Off switch commands with a (rocker) switch or 1-pole,

normally open contact, Momentary switch

Action Sending

Send an address (2 x) A1...P16

Send setup command (2 x) ON

Send setup command for any options (2 x) All Lights ON, All Lights OFF, All Units OFF

Example of programming on address B03

Action No. of LED flashes

Send address B03 (2 x) 2 x

Send set-up command ON (2 x) 3 x

Optional:

If the status of the module has to change with group commands All Lights On

and All Units Off.

Action No. of LED flashes

Send All Lights On (2 x) 2 x

Send All Units Off (2 x) 4 x

Result

• ON/OFF function available for all inputs.

• Other inputs are automatically given consecutive addresses..