User manual

INSTALLATION

• Switch off appropriate mains fuse and master switch!

• Where present, take the wall switch out of the wall box.

• Disconnect all wires from the switch.

• Connect the live (brown) and load wire (black) to the terminals of

the LW12 as described in figure A.

• Replace your normal make/break contact switch by a momentary

switch.

• Connect a load wire (brown) to the momentary switch (CAUTION:

In the interest of safety and to make the device work properly, this

load wire HAS TO be from the same group).

• Connect a black wire to the output of the switch. Connect the

other end of this black wire to the input K of the LW12

MicroModule. See figure A.

• Place the module against the back of the wall box and replace the

switch inside the box.

• Switch on mains fuse and master switch.

1. Lamp

2. Neutral (blue)

3. Live (brown)

4. Momentary Switch

5. Load (black)

6. Switch input (black)

Figure A.