User manual

FREQENTLY ASKED QUESTIONS
What is the reason for modules to switch on/off spontaneously?
It is possible that a Marmitek X-10 System is installed at one of your
neighbours using the same House Code. To solve this problem try to
change the House Code of your system, or have FD10 Phase
Coupler/Filter installed at your incoming mains.
My modules will not respond to my controller.
Make sure that the House Code on all Modules and Controllers are
set to the same House Code (A .. P).
My modules will not react to my remote / sensor.
When you use a remote or sensor, you should have at least one TM13
Transceiver or Marmitek Security Console installed in your house.
These components will translate the radio signals to the Marmitek X-
10 signal on the power line. Only one Transceiver should be installed
for all remotes and sensors set to the same House Code.
Am I able to increase the range of my remotes by using more
Transceivers?
Yes, you can use more than one TM13 Transceiver in your home when
the range of your remotes is not sufficient. The TM13 is using so called
collision detection to prevent signals to be disturbed when more than
one TM13 is transmitting. TM13’s will wait for a quite power line
before transmitting their data. To prevent your Marmitek X-10 System
to become slow or to prevent dimming from becoming less smooth,
make sure that the TM13 units are placed as far away from each other
as possible.
11LW12