User manual

Resetting the LW12

When leaving the factory, the LW12 is set to the default address A1

en does not respond to the optional functions All Lights On/All Lights

Off/All Units Off. If the address and settings for the options "All lights

on/All lights off /All Units Off" aren’t known, the default address of

A1 can be set by applying power to the unit and sending the address

P16 to the unit twice (using any X-10 controller - i.e.: TM13 + RF

remote control).

This can either be just the address "P16" or "P16 On" or "P16 Off".

The commands must be sent within 30 seconds of applying power to

the unit. Setting the default address automatically cancels the options

"All Lights On", "All Lights Off" or "All Units Off".

Exiting the programming mode

Automatic: Wait for 1 minute. The device will then automatically exit

the program mode. Manually: To return to Run Mode: either send

"Address On", "Address Off" or press the key quickly (no more than

1. 5 seconds between key presses). After 5 key presses or "On/Off"

commands, the LW12 will start to respond, indicating that the unit is

back in Run Mode.

Detailed information on the type of switch

If the connected momentary switch is used, the status of the LW12

will change if the button is pressed for less than 2 seconds. If the

momentary switch is pressed for a longer duration, the LW12 will dim.

The module first dims all the way down and then back up.