User manual

TM13

ENGLISH

DEUTSCH

FRANÇAIS

ESPAÑOL

ITALIANO

NEDERLANDS

FIRST USE OF THE TM13

1. Set the HouseCode (A to P) of the Home Control TM13

Transceiver to the same code as you have set your other

modules. The UnitCode cannot be set and will always be

‘1’. If the TM13 is set to HouseCode ‘P’, all commands

from remote controls will be converted into an X-10

signal over the mains, regardless of the HouseCode. The

HouseCode used will in this case be the same as the

HouseCode of the remote control.

2. Point the antenna upwards.

3. Plug the Home Control TM13 into a socket (preferably in

a central location of your house).

4. Insert the plug of an appliance or light in the module.

This can now be controlled using the ‘1’ button of your

remote.

Normally speaking, only one TM13 will be required per

installation if wireless controllers are used that are set to the

same HouseCode (Does not apply to TM13EFL). The TM13

includes a so-called ‘collision detection’ system. This prevents

problems from occurring when several TM13 modules are

used and it allows expansion of the RF range by using several

TM13 modules that are set to one and the same HouseCode.

The module responds to the following Marmitek X-10

commands: ‘ON’, ‘OFF’ and the Marmitek X-10 group

command ‘All Units Off’.