SECURITY SYSTEM WITH BUILT-IN TELEPHONE DIALLER HOMEGUARD MS8000 OMEGUARD MS800 OWNER’S MANUAL 2 option KR21 art. no.
1. SAFETY PRECAUTIONS: 3 2 5 1 a. HomeGuard is designed for indoor use only. b. Use HomeGuard only in dry places c. The supplied power adapter is designed for use for 230V only d. Do not open the power adapter, as there is dangerous voltage inside. No serviceable parts are located inside. e. In case of any need for service, contact your nearest Marmitek Authorised Service Centre (MASC). f.
8. External alarm contact: This input allows you to connect any external alarm device with a non-powered NO (Normally Open) or NC (Normally Closed) contact. E.g. smoke alarms, magnetic door/window contacts, flood and temperature detectors, etc. You may connect multiple devices in series to the HomeGuard. This allows you to turn your HomeGuard into a complete security system with built-in telephone dialler.
d. The sensor should not be placed above or near heating elements or in front of air-conditioners. e. Do not mount the sensor on a metal surface or next to electrical equipment such as TV sets or computers. Caution: a. Radio equipment (e.g. wireless headphones or loudspeakers) working on a frequency band of 433MHz will not create a false alarm, however, these devices will limit the RF range of the remote control considerably. b. Pets, e.g.
has been entered by more than one HomeGuard, you can transmit an extra audible signal with the pre-recorded message in order to identify the HomeGuard calling. The factory default is one beep at the end of the message. To change the number of beeps (1, 2 or 3): 1. Enter your PIN 2. Press 4 on the keyboard 3. Press 1, 2 or 3 for the required number of identification beeps. 7. REGISTERING REMOTE CONTROLS (HANDSHAKE) HomeGuard can be remotely controlled by up to 4 radio remotes (1 piece KR21 supplied).
10. DE-ACTIVATING THE BUILT-IN MOTION SENSOR: If you prefer to operate the HomeGuard only by means of the external alarm contact rather than the built-in motion sensor, you can de-activate the PIR: 1. Enter your PIN (Personal Identification Number). Factory default is [0000]: You will hear three high tones and one low tone as confirmation. The green indicator starts flashing. 2. Press 6 on the keyboard of the HomeGuard: One low tone is given for confirmation. 3.
NOTE: Instruct the person who’s number has been entered to give the confirmation 0 just after the beep(s). Since telephone answering machines or voice mail facilities will not generate the confirmation, these will be ignored. It is recommended to do a test with the people involved in order to let everyone get aquatinted with the system. 12. TROUBLESHOOTING: 1. The base station does not react at all, the green indicator is not on: Check the power supply and/or the replace the back-up battery. 2.
PIR of sirene reageren niet: Ga na of de PIR of SIRENE zijn ingeschakeld. De sensor reageert niet op de afstandsbediening: Volg de instructies op voor het aanmelden van afstandsbedieningen. Ga na of de indicator op de afstandsbediening aan gaat wanneer u op de toetsen drukt. Wanneer dit niet het geval is dient u de batterij te vervangen. Bij andere problemen: Haal de adapter uit het stopcontact en verwijder de back-up batterij.