User`s guide

X10CONFIG(5) X10CONFIG(5)

MDY=>Month/Day/Year

and where the optional <separator> is ´/´ (Default), ´-´, or ´.´

Examples:

DATE_FORMATYMD ´/´ => 2008/01/23 (Heyu default)

DATE_FORMATYMD ´-´ => 2008-01-23 (ISO 8601 standard)

DATE_FORMATDMY ´-´ => 23-01-2008 (manyEuropean countries)

DATE_FORMATDMY ´.´ => 23.01.2008 (Germanytraditional)

DATE_FORMATMDY ´/´ => 01/23/2008 (USA traditional)

The speciﬁed order of Month and Day also applies to the date ranges speciﬁed for Timers in schedule ﬁles

to be uploaded to the CM11A EEPROM. The separator between month and day must be ´/´, ´-´ or ´.´ but

does not have tobethe same as that speciﬁed with DATE_FORMAT. The separator between the begin and

end dates may optionally be either ´-´ or ´:´. (Use the latter for clarity when the Month/Day separator is a

´-´.)

Examples:

TIMER smtwtfs 01/23-12/31 ... (with DATE_FORMATYMD or MDY)

TIMER smtwtfs 23-01:31-12 ... (with DATE_FORMATDMY)

Dates where the month name is spelled out are not affected by this directive and usually appear like:

Wed23Jan 2008

LOGDATE_YEAR directive

Instructs Heyu whether or not the dates reported for entries in the Log ﬁle and Monitor should include the

year.The choices are YES or NO, with the default being NO, to omit the year.

TAILPATHdirective

Use this directive tospecify the full pathname of the system ´tail´ command if it´s not on the normal PATH

accessable to Heyu. The Heyu command ´logtail´ will use this pathspec to call ´tail´.

HEYU_UMASK directive

Governs the permissions for ﬁles created by Heyu. The default for this directive is0000 which results in

ﬁles having permissions rw_rw_rw_. The value 0002 results in ﬁles having permissions rw_rw_r__ ; the

value 0022 results in ﬁles having permissions rw_r__r__.

Example:

HEYU_UMASK 0002

USERSYN directive

SCENE directive

These directives, newtoHeyuversion 2, specify a semicolon-separated list of Heyu commands. These can

then be executed sequentially by issuing only the usersyn or scene label as a Heyu command. In addition,

the label can be used in a macro as if it were a command.

In the current release, the ONLYdifference between a SCENE and USERSYN is whether theyappear in

the scene or usersyn list displayed by the ´heyu show´ command. What applies belowfor a SCENE applies

equally to a USERSYN.

The format for either a scene or usersyn is similar:

SCENE Label command1; command2; command3; ...

USERSYN Label command1; command2; command3; ...

The commands in a scene can accept either actual device addresses or aliases. (The alias directive must

appear before anyscene directive which references it.)

Examples:

local 9