Specifications

9.16: Daylight Savings

Using the Daylight Savings option, the system is able to automatically adjust its clock twice

a year according to the national adjustment to Daylight Saving Time.

Two options are available:

x Europe – the clock is adjusted forward 1hr on the last Sunday in March

at 2am, the clock is adjusted back 1hr on the last Sunday in October at

3am.

x USA– the clock is adjusted forward 1hr on the first Sunday in April at

2am, the clock is adjusted back 1hr on the last Sunday in October at

2am.

From 2007, Daylight Saving Time in the USA begins on the second Sunday in March and

ends on the first Sunday of November. This modification has been accounted for in the

firmware and the time shall be updated automatically according to the new dates from

2007 onwards.

To program the Daylight Savings option:

1. From the Programming menu, select System Options, Daylight

Savings [9416].

2. Select Europe, USA or Disabled.

9.17: Report Fail Trouble

If the Report Fail Trouble option is enabled, failure to report an event displays System

Trouble on the LCD display. Report Fail Trouble is displayed after the control panel has

exhausted all message attempts and report cycles when trying to report the event. To

restore a System Trouble condition caused by failure to report, press  until you have

scrolled through the entire system trouble list. If the Report Fail Trouble is disabled,

failure to report an event does not cause a system trouble condition.

To program the Report Fail Trouble option:

1. From the Programming menu, select System Options, Rep. Fail Trb. [9417].

2. Select Enabled or Disabled.

9.18: Cancel Alarm

The Cancel Alarm feature is an option that allows the user to cancel a false alarm by

disarming the system within five minutes of reporting the alarm. Cancelling an alarm

causes the control panel to report a Cancel event to the monitoring station and an enter

an Alarm Cancelled event in the event log. Following a cancelled alarm, the message

Alarm Cancelled, OK? appears on the keypads’ LCD until the user presses 3 to

confirm. Until confirmation is received, the control panel does not allow any local function

to be performed. However, the control panel may perform remote commands received

via Telecontrol or Remote Programming regardless of this system status. Please note

that alarm indication has higher priority and overrides the “Alarm Cancelled” display.

As this control panel has been designed to meet the requirements of the ANSI/SIA

CP-01 standard for false alarm reduction, it is not possible to disable the Cancel Alarm

feature. Consequently, the system will reject any attempt to change the default setting of

the menu item System Options, Cancel Alarm [9418].