Specifications

7.8.1: Keypad SOS Panic Alarm Activation
Using any of the wireless keypads, you can
activate an SOS Panic alarm by pressing the
Full and Perimeter arming keys simultaneously.
Figure 7.4 illustrates how to activate an SOS
Panic alarm on the WK820 wireless keypad.
7.9: Repeaters
Repeaters are designed to extend the wireless range of the control panel. Up to four
repeaters may be registered to the system with a maximum of 32 transmitters associated
with each receiver. For information on registration, descriptor editing and deletion, see
sections 7.1, 7.2 and 7.3, respectively.
7.10: Wireless Siren
For the wireless siren to function, the control panel must have the on-board transmitter
installed on the Main board – see 1.4.1: The Main Board for the location of the on-board
transmitter connector.
Using this transmitter, the system sends alarm and arm status information to the wireless
siren’s receiver. This requires that you register the transmitter to the wireless siren’s
receiver.
To register the on-board transmitter to the wireless siren’s receiver:
1. Set the wireless siren’s receiver to Registration mode – refer to the
siren’s installation instructions for further information.
2. Activate the siren using the WL Siren Test feature – see 4.7.3:
Wireless Siren Test.
3. Activate the siren again; the on-board transmitter is registered to the
siren’s receiver.
When installing 2-way sirens, the wireless siren also includes a transmitter that must be
registered to the control panel. For information on registration and deletion, see sections
7.1 and 7.3, respectively.
7.10.1: Wireless Siren Type
The control panel supports both 1-way and 2-way wireless sirens. For this feature to
function correctly, you must define the wireless siren type in programming.
The following options are available:
x 1-Way Siren – if using the ProGuard800 SI825 status indicator.
x 2-Way Siren – if using the OS826 wireless siren.
x 2-Way Siren/Kpd – if using the OS826 wireless siren and the 2-way
WK820SI keypad (this option is for future use).
To program the wireless siren type:
1. From the Programming menu, select Devices, Siren, WL Siren Type
[9152].
2. Select a siren type or No WL Siren if no siren is installed.
ProGuard800™ -51-