Specifications

7.6.7: Repeater
The RP835 repeater is an additional module that extends the range of the wireless
transmitters. For a sensor to use the repeater to relay transmissions to the system, you
must define the Repeater option for its zone as “Use Repeater”.
To program the Repeater option:
1. From the Programming menu, select Devices, Zones [911].
2. Select the zone you want to program.
3. From the zone’s sub-menu, select Repeater [#09]; the zone’s current
Repeater setting is displayed.
4. Select either No Repeater or Use Repeater.
7.7: Keyfobs
The ProGuard800 supports two types of Keyfob transmitter, PR811 and KR814. You can
register up to 19 Keyfobs to the system. Figure 7.1 illustrates these transmitters and the
functions assigned to their buttons. For information on registration, descriptor editing and
deletion, see sections 7.1, 7.2 and 7.3, respectively.
Arm
Disarm
B1:
Part
B2:
Perimeter
Medical
Emergency
PR811 KR814
Figure 7.1: Keyfob Button Assignments
The following sections explain the programming options exclusive to the KR814 Keyfob
transmitter. These programming options are not relevant to the PR811.
7.7.1: Keyfob Type
You can define each registered Keyfob as Controlled or Non-controlled. A Controlled
Keyfob causes the system to send arm/disarm event messages to the monitoring station.
Non-controlled Keyfobs never send arm messages and send a disarm message only if
the system is disarmed after an alarm occurrence.
To program a Keyfob type:
1. From the Programming menu, select Devices, Keyfobs [912].
2. Select the Keyfob you want to program.
3. From the keyfob’s sub-menu, select Type [#2]; the current setting is
displayed.
4. Select either Controlled or Non-controlled.
7.7.2: Button Assignment
The KR814 includes two buttons (B1 and B2) that you can program individually. The
default functions for B1 and B2 offer different arming methods. Alternatively, you can
program these buttons to control a specific HA unit.
ProGuard800™ -49-