Specifications

To delete a device:

1. From the Programming menu, select Devices, [91].

2. Select the type of wireless device you want to delete.

3. From the device’s sub-menu, select Delete.

4. Press 3 to confirm; the device is deleted.

7.4: Supervision Time

The sensors in Marmitek’s ProGuard800 supervised wireless range send a supervision

signal approximately one hour after its last transmission. If the system does not receive

supervision signals from a specific transmitter, the transmitter is regarded as inactive.

The amount of time after which a transmitter is considered inactive is called the

Supervision Time. There is a separate supervision time for general transmitters and

devices that are registered to Fire zones.

To program the Supervision Time for general transmitters:

1. From the Programming menu, select Devices, Superv. Time, General

[9161].

2. Enter a supervision time between 04:00 and 23:59 hours.

To program the Supervision Time for transmitters registered to Fire zones:

1. From the Programming menu, select Devices, Superv. Time, Fire

[9162].

2. Enter a supervision time between 02:00 and 23:59 hours.

7.5: Re-Synchronization

Transmissions that are out of synchronization are rejected by the system. For example, it

is not possible to arm or disarm the system using a keyfob that is out of synchronization.

In the event that a transmitter is out of synchronization, it is possible to re-synchronize

the transmitter and restore normal operation.

To re-synchronize transmitters:

1. From the Programming menu, select Devices, TX Re-synch [917]; a

10-minute time window is opened.

2. During the 10-minute time window, if a transmission is received that is

out of synchronization, the transmitter is re-synchronized.

7.6: Zones

The ProGuard800 includes 33 security zones. Zones 1-32 are intended for wireless

sensors. One sensor can be registered to each wireless zone. The system supports

Marmitek’s ProGuard800supervised wireless range of transmitters that includes various

PIR sensors, magnetic contacts and smoke detectors. All these transmitters send

supervision signals to the panel’s receiver in order to indicate that the transmitter is

functional.

Zone 33 is an on-board hardwire zone. This zone is programmed in the same way as the

wireless zones with the exception of registration and deletion.