Specifications

Chapter Seven: Devices
This chapter explains how to register devices to the system and the programming options
for each device. For further information, please refer to the installation instructions
included with each device.
7.1: Device Registration
For the system to recognize individual devices, each device must be registered to the
system. For example, if the device is a wireless transmitter, registration enables the system
to identify the source of a received transmission. Each device has an individual encrypted
ID code. Registering the device to the system familiarizes the system with this code.
1
It is not necessary to register hardwire sensors connected to Zone 33.
To register a device to the system:
1. From the Programming menu, select Devices [91].
2. Select the type of transmitter you want to register. For example, if you
want to register a wireless sensor to a zone, select Zones.
3. Select the specific device you want to register (for example, Zone 4);
the system initiates Registration mode. During Registration mode, the
system waits for two transmissions from the device.
1
If a device has already been registered at the required location, the system will not initiate
Registration mode. If the device has already been registered at another location, attempts
to register are ignored by the system
4. Register the device – refer to each device’s installation instructions in
Appendix B for further details.
5. When two transmissions have been received, Save? is displayed.
6. Press 3to confirm registration, or 2 to cancel.
7.2: Device Descriptors
You can assign a 16-character descriptor to each device except the wireless siren.
These descriptors help identify the devices when you operate and program the system.
To edit a device descriptor:
1. From the Programming menu, select Devices [91].
2. Select a device type.
3. From the device’s sub-menu, select Descriptor.
4. Edit the descriptor using the alphanumeric keypad.
5. Press 3 when you have finished editing.
7.3: Device Deletion
When you want to remove a device from the system, you have to delete the device. It is
important to delete unused devices for two reasons. Firstly, you have to delete a device
before you can register a new transmitter in its place. Secondly, if the device is a wireless
sensor, it is important to delete the device so that the system will not react to the
transmitter’s failure to send supervision signals.
ProGuard800™ -45-